UNIPOWER
UP-2210R/P Hardware installation and configuration manual
3.1 Measuring device
The measuring device UP-2210 is an advanced, 3-phase power quality and disturbance analyser
designed for permanent installation. There are different models, UP-2210 wall mount and UP-
2210R/P rack/panel mount.
UP-2210 Rack and panel mount
UP-2210 wall mount
3.2 Communication
All measured data is automatically transferred from the meter to the server. There are several options
for communication between the meters and the computer centre. The meters may be equipped with
RS-232, RS-485, built-in modems and dual Ethernet ports. This means that communication is
possible using a range of media, such as a standard telephone lines, signal cables, GSM phones, local
computer networks, etc. Different meters can use different communication options within the same
system, creating a highly flexible communication solution. The dual Ethernet ports makes it possible
to connect to two completely isolated networks. The dual Ethernet ports makes it possible to connect
to two completely independent networks. Note that for security reasons the ports are isolated and
there is no function that can transfer data between the two networks. Both ports supports TCP/IP and
UDP/IP but cannot be connected to the same network. ETH1 has the top priority and is the only port
supporting NTP and SmartCom. Modbus uses TCP/IP but only allows one connection at a time.
There is no function making it possible to transfer data between the two ports.
Figure 2
To Next Page
Loading...
Need help?
General
