United Parachute Technologies Vector 3 - Page 60

VECTOR3MANUAL
MAN‐004REV7.2537/20/2017

METHODB—SPECTRALINES(MICROLINES)(WITHFINGER‐TRAPPEDANDSEWNENDS)
Afterthemaincanopyhasbeenproperlyattachedtotherisersandwhileitisstilllyingonitsside,attachthetogglesto
it
byfollowingthesesteps:

1.Startingatthetailofthecanopy,tracethe
uppersteeringlinesdowntothelowersteering
line.Thisistoensurethesteeringlinesare
routedcorrectly;theyshouldnotwraparound
anysuspensionlines.Theright‐handsteering
linemustpassthroughthe
right‐handrearslider
grommet,andtheleft‐handlinemustpass
throughtheleft‐handrearslidergrommet.

2.Threadtheendofthesteeringlinethrough
theguideringlocatedontheriserthenthrough
thegrommetlocatedontoggle.

3.Pulltheloopovertheendof
thetoggleas
shown.
