Setup and Registration
6-8
If user management or account management is
enabled, the login screen will appear. For the login
procedure, refer to Account Management on
page 4-48.
2 Press the or key to select [Fax].
3 Press the OK key.
4
Press the
or
key to select [Transmission],
[Reception], [TX/RX Restrict.] or [TX/RX Common].
Configuring settings from [Transmission]
• Retry Times (page 6-13
)
• ECM TX (page 6-13
)
• TX Start Speed (page 6-13
)
Configuring settings from [Reception]
• Media Type for Print Output (page 6-14
)
• Rings (page 6-16
)
• Receiving Mode (page 6-17
)
• Reception Date/Time (page 6-18
)
• 2 in 1 Reception (page 6-19
)
• Print all at once [Batch Print] (page 6-20
)
• Procedure for receiving an encrypted
transmission (page 6-25
)
• Duplex Print Output (page 6-27
)
• ECM RX(page 6-28
)
• RX Start Speed(page 6-29
)
Configuring settings from [TX/RX Restrict.]
• Transmission Restriction (page 6-30
)
- Registering, changing, and deleting Permit fax
numbers (page 6-31
, page 6-32)
- Registering, changing, and deleting Reject fax
numbers (page 6-34
, page 6-35)
- Transmission restriction settings (page 6-38
)
- Reception restriction settings (page 6-39
)
- Registering, changing, and deleting Permit ID
numbers (page 6-36
, page 6-37)
- Checking and deleting the registered contents
of an encryption key (page 6-22
, page 6-22)
- Unknown Number Reception (page 6-39
)
Configuring settings from [TX/RX Common]
• Setting an encryption key for encrypted
transmission (page 6-22
)
5 Press the OK key.
6 Move to the screen where you want to configure a
setting. (Follow the procedure in the explanation of
the setting.)
To Next Page
Loading...
