Troubleshooting
8-2
Indicators During Sending/Receiving Operation
The Processing and Memory indicators show the fax
transmission status.
•The Processing indicator blinks when the machine
is sending/receiving a fax.
•The Memory indicator blinks when source data is
being stored in memory for memory transmission.
•The Memory indicator is lit when there is source
data stored in the memory for delayed
transmission.
Responding to an ATTENTION Indicator Flashes
If an ATTENTION indicator flashes, press [Status/Job Cancel] to check an error message. If the message is not
indicated on the Message Display when [Status/Job Cancel] is pressed or the ATTENTION indicator flashes,
check the following.
Symptom Checkpoints Corrective Actions Reference Page
Cannot send fax. Is the modular cord
connected correctly?
Connect the modular
cord correctly.
—
Is Permitted FAX No. or
Permitted ID No.
registered correctly?
Check Permitted FAX
No. and Permitted ID
No..
6-30
Has a communication
error occurred?
Check error codes in the
TX/RX Result Report
and Activity Report. If
the error code starts with
"U" or "E", perform the
corresponding
procedure.
Appendix-12
Is the destination FAX
line busy?
Send again. —
Does the destination
FAX machine respond?
Send again. —
Is there an error other
than above?
Contact your Service
Representative.
—
To Next Page
Loading...
Need help?
General
