FAX Operation (Advanced)
4-12
2 Lift the handset of the telephone.
3 Check if the telephone line has connected to the
fax of the sending system.
When you hear the fax tone
The sending system is on fax.
1 Press the Status/Job Cancel key.
2 Press the On Hook key.
3 Press [ManualRX] (the Left Select key).
Reception will start.
NOTE: When using a telephone set that can
send tone signals, use the telephone to start the
reception of originals with the remote switch
function. (Refer to Remote Switch Function on
page 4-13.)
When you hear a voice from the receiving
system
The telephone line has connected to the telephone
of the sending system. When the conversation is
over, follow steps 1 to 2 above.
After the sending system has started transmission,
the machine starts receiving originals.
4 When reception starts (when the Processing
indicator on the operation panel starts blinking),
return the handset to its original position.
To Next Page
Loading...
