Valmet TS - Page 12

D
D
A B
Measuring line at a 90° angle
towards the pump axis.
Measuring line parallel to
the previous horizontal pipe.
Fig. 2. Installing the sensor to a vertical pipeline: A. after a pump, B. after a horizontal pipe section.
D
D
A B
Fig. 3. Installing the sensor to a horizontal pipeline: A. after a bend, B. after a vertical pipe section. If the section
of horizontal pipe preceding the sensor is >10xD, then the sensor is installed with its electronics casing on top.
Installation & Owner's manual, OUL00489 V2.3 EN
12
Valmet Total Solids Transmitter