Table of contents
Warnings & safety information
Recycling and disposal
Introduction 71.
Measurement principle ....................................71.1.
Parts of the device...........................................71.2.
Sensor device plate..........................................81.3.
Construction 92.
Valmet TS-FT...................................................92.1.
Sensor electronics .........................................102.2.
Transmitter Central Unit (TCU) .....................102.3.
Installing 113.
General principles..........................................113.1.
Choosing the installation site.........................113.2.
Installation dimensions...................................133.3.
TCU and its shield..........................................143.4.
Electric connections ......................................143.5.
Setting up 174.
Checking the hardware..................................174.1.
Installing.........................................................174.2.
Checking the cable connections....................174.3.
Checking electric operation............................174.4.
Configuration and calibration.........................174.5.
User interface and operating 195.
Operating unit, TCU.......................................195.1.
Operating diagram.........................................205.2.
Configuration 216.
Configuration menu........................................216.1.
Choosing and scaling the output signal.........216.2.
User settings..................................................216.3.
Device info ....................................................226.4.
Setting date & time.........................................226.5.
Address..........................................................226.6.
Digital inputs ..................................................226.7.
Calibration 237.
About calibration............................................237.1.
Sample taking................................................237.2.
Entering laboratory results.............................247.3.
Offset correction.............................................247.4.
Calibration and sample history ......................247.5.
Diagnostics 258.
Diagnostics menu...........................................258.1.
Error table......................................................258.2.
Diagnostics values.........................................258.3.
Diagnostics limits...........................................268.4.
Special functions 279.
Special functions menu..................................279.1.
Chemical compensation.................................279.2.
Sensitivity correction .....................................309.3.
Recipes .........................................................319.4.
Troubleshooting 3310.
Troubleshooting procedures .........................3310.1.
Effect of process conditions on
measurement.................................................33
10.2.
Self-diagnostics error messages ...................3510.3.
Replacing components 3711.
Pressure test of sensor housing....................3711.1.
Sensor electronics..........................................3811.2.
Antenna cables, FT-sensor............................3911.3.
Antennas, FT-sensor......................................4011.4.
TCU ...............................................................4011.5.
HART user interface 4112.
About the interface.........................................4112.1.
Measurement.................................................4212.2.
Configure........................................................4212.3.
Calibrate.........................................................4312.4.
Diagnostics.....................................................4612.5.
Installation drawings
Technical specifications
Spare parts
Atex certificate
Declaration of conformity
Installation & Owner's manual, OUL00489 V2.3 EN
3
Valmet Total Solids Transmitter
To Next Page
Loading...