VAMP 260 - Configuring Digital Inputs DI; Configuring Digital Outputs DO

VAMP 260 Power monitoring unit
Operation and configuration
VAMP Ltd
24
Vamp 24h support phone : +358 (0)20 753 3264
VM260.EN004
Available links:
• S, Q, P
• f
• PF
• TanFii, CosFii
• I2/I1, I2, I1, Io, ILmax, IL3, IL2, IL1
• THDIL3, THDIL2, THDIL1
• UL3, UL2, UL1, ULLmax, ULLmin, U31, U23,
U12
• U2/U1, U2, U1, Uo, ULNmax, ULNmin
• THDUc, THDUb, THDUa
• IL
• Uphase, Uline
• DO, DI
5.3. Configuring digital inputs DI
Via the submenus of the digital inputs menu the following
functions can be read and set:
• Status of digital inputs (DIGITAL INPUTS)
• Operation delay (DELAYs for DigIn)
• Polarity of the input signal (INPUT POLARITY), either
normally open (NO) or normally closed (NC) circuit
• Selection to event register EVENT MASK1 and EVENT
MASK2
5.4. Configuring digital outputs DO
Via the submenus of the digital outputs menu the following
functions can be read and set:
• Status of the output relays (RELAY OUTPUTS1 and 2)
• Forcing of the output relays (RELAY OUTPUTS1 and 2)
(only if Force = ON):
o Forced control (0 or 1) of the Trip relays T1 and T2
o Forced control (0 or 1) of the Alarm relays A1…A3
o Forced control (0 or 1) of the IF relay
• Configuration of the output signals to the output relays T1
and T2, A1 – A3 and the operation indicators.