VAMP 260 - Protocol Menu Bus

To Next Page

To Previous Page

VAMP Ltd Power monitoring unit

Operation and configuration

VAMP 260

VM260.EN004 Vamp 24h support phone : +358 (0)20 753 3264

5.8. Protocol menu Bus

Via the submenus of the protocol menu the following functions

can be read and set:

PROTOCOL

• Communication protocol of REMOTE port (Protoco)

• Message counter (Msg#)

• Communication error counter (Errors)

• Communication time-out counter (Tout)

MODBUS

• Device slave number at Modbus Slave Protocol or

Target slave number at Modbus Master Protocol (Addr)

• Modbus transfer rate (bit/s)

• ModBus parity check (Parity)

SPABUS SLAVE

• Slave number (Addr) when unit connected to SPA-Bus

• SPA-Bus transfer rate (bit/s)

• Event mode (Emode)

ProfiBus DP

• ProfiBus profile (Mode)

• Transfer rate of converter (bit/s)

• ProfiBus Tx Buf length (InBuf)

• ProfiBus Rx Buf length (OutBuf)

• ProfiBus address (addr)

• Type of the ProfiBus converter (conv)

IEC-60870-5-103

• Slave address (Addr)

• Transfer rate (bit/s)

TCP/IP (Only in VAMPSET)

•

IP address of the unit (IpAddr)

• Subnet mask (NetMsk)

• IP address of the Gateway (Gatew)

• IP address of the Name Server (NameSv)

• IP address of the SNTP Server (NTPSvr)

• IP port number for protocol (Port)