VAMP 260 - Configuration Menu CONF

VAMP 260 Power monitoring unit
Operation and configuration
VAMP Ltd
28
Vamp 24h support phone : +358 (0)20 753 3264
VM260.EN004
5.9. Configuration menu CONF
Via the submenus of the configuration menu the following
functions and features can be read and set:
DEVICE SETUP
• Transfer rate of local serial bus (bit/s)
• Restart device (Reset)
• “AccessLevel” display (Acc)
SCALING
• Rated VT Primary (Unom)
• Rated VT secondary (Usec)
• Voltage Meas. Mode (Umode)
• Rated CT primary current (Inom)
• Rated CT secondary current (Isec)
DEVICE INFO (only display)
• Unit type (Type VAMP 260)
• Serial number (SerN)
• Software version (PrgVer)
DATE/TIME SETUP
• Date (Dat)
• Time (Time)
• Presentation style of date information (Style)
CLOCK SYNC
• Minute sync pulse DI (SyncDI)
• Sync correction (SyOS)
• RTC Trim (CkTrim)
• Sync source (SySrc)
• Time zone for NPT (Tzone)
• NTP daylight saving time (DST)
CLOCK SYNC 2
• Sync message counter (MsgCnt)
• Latest time deviation (Dev)
• Filtered sync deviation (FilDev)
• Cumulative deviation (I)
• Max clock adjust (MaxAdj)
• Min clock adjust (MinAdj)