VAMP 52 - 2.4.7. Protection menu Prot

Operation and configuration 2 Local panel user interface 2.4 Configuration and parameter
setting
2.4.6. Configuring analogue outputs AO (Option)
Via the submenus of the analogue output menu the following
functions can be read and set:
ANALOG OUTPUT
 Value of AO1 (AO1)
 Forced control of analogue output (Force)
ANALOG OUTPUT
 Value linked to the analogue output (Lnk1)
 (See list available links)
 Scaled minimum of linked value (Min)
 Scaled maximum of linked value (Max)
 Scaled minimum of analogue output (AOmin)
 Scaled maximum of analogue output (AOmax)
 Value of analogue output (AO1)
Available links:
 IL1, IL2, IL2
 F
 IL
 Io, IoCalc
 U12
 UL1
2.4.7. Protection menu Prot
The following functions can be read and set via the submenus
of the Prot menu:
 Reset all the counters (PROTECTION SET/ClAll)
 Read the status of all the protection functions (PROTECT
STATUS 1-x)
 Enable and disable protection functions (ENABLED
STAGES 1-x)
 Define the interlockings using block matrix (only with
VAMPSET).
Each stage of the protection functions can be disabled or
enabled individually in the Prot menu. When a stage is
enabled, it will be in operation immediately without a need to
reset the relay.
The relay includes several protection functions. However, the
processor capacity limits the number of protection functions
that can be active at the same time.
VM50.EN004 VAMP 24h support phone +358 (0)20 753 3264
29