EasyManua.ls Logo

Vanair Goodall CAP-START - Maintenance, Parts, and Troubleshooting; Maintenance Program and Replacement Parts

Vanair Goodall CAP-START
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SECTION 5:
MAINTENANCE
SECTION 5: MAINTENANCE
090189-OP_r0 (JUNE-2022) 5 - 1
VANAIR MANUFACTURING, INC.
(844) VAN-SERV • www.vanair.com
Cap•Start Hydraulic-Driven
12V/24V • Battery Starter • Charger
5.1 GENERAL INFORMATION
A strict maintenance program is the key to long
life for the Cap•Start Hydraulic-Driven Package
Below is a program that, when adhered to, should
keep the package in top operating condition.
The following table lists the main topics in order
of appearance for this section:
DANGER
Disconnect the capacitor before performing
any non-routine maintenance functions on the
Cap•Start Hydraulic-Driven Package.
WARNING
DO NOT discharge the capacitor.
WARNING
DO NOT short the capacitor.
WARNING
Follow all applicable safety recommendations
as outlined in Section 1: Safety of this manual.
WARNING
Wear personal protective equipment such as
gloves, work boots, and eye and hearing pro-
tection as required for the task at hand.
NOTE
Operating the machine package in a severe
environment may require more frequent service
intervals.
5.2 REPLACEMENT PARTS
Replacement parts should be purchased through
your local Vanair
®
representative or where the
Cap•Start Hydraulic-Driven Package was pur-
chased. If, for any reason, parts are not available
in this manner, they can be purchased from Va-
nair directly.
IMPORTANT
Table 7A: Recommended Spare Parts List, in
Section 7, contains items that require mainte-
nance on a routine basis, and also those parts
that may require maintenance over the course of
the
Cap•Start Hydraulic-Driven Package’s perfor-
mance schedule. Although this recommended list
is pro ered as a comprehensive guide to replace-
ment parts, damage may occur to the machine
beyond the scope of this listing.
Should any part of the
Cap•Start Hydraulic-Driven
Package become damaged or inoperable, use the
various sub-sections in Section 7 to best locate
and identify the damaged part(s).
VANAIR MANUFACTURING, INC.
10896 West 300 N.
Michigan City, IN 46360
Telephone: (800) 526-8817
(219) 879-5100
Service: (844) VAN-SERV
(844) 826-7378
Service Fax: (219) 879-5335
Parts Fax: (219) 879-5340
Sales Fax: (219) 879-5800
www.vanair.com

Table of Contents