SECTION 3:
INSTALLATION
SECTION 3: INSTALLATION
. 090189-OP_r0 (JUNE-2022) 3 - 1
VANAIR MANUFACTURING, INC.
(844) VAN-SERV • www.vanair.com
Cap•Start Hydraulic-Driven
12V/24V • Battery Starter • Charger
3.1 MACHINE PACKAGE
RECEIPT/INSPECTION
Upon receipt of the machine package, inspect the
exterior of the shipping crate for signs of shipping/
transit damage. Any damage should be reported
immediately to the shipping company.
NOTE
Before fully unpacking the unit, inspect the
component parts, supports and loose-packed
parts to ensure that there have been no inter-
nal movements of assemblies or components,
which may have been damaged during ship-
ment.
Should any damage be discovered during pack-
age inspection, contact the shipping company
immediately.
VANAIR MANUFACTURING, INC.
(219) 879-5100 / (800) 526-8817
Service (toll free): (844) VAN-SERV
(844) 826-7378
Service Fax: (219) 879-5335
www.vanair.com
3.2 GENERAL INSTRUCTIONS
This section provides general guidance for locat-
ing and preparing the Cap•Start Hydraulic ma-
chine package for operation. Each installation
is unique and can be aff ected by location, ven-
tilation, and other factors such as electrical and
hydraulic power supply availability and location.
DISCLAIMER
DO NOT install in any enclosed space without
fi rst contacting Vanair.
WARNING
Install, operate, and maintain this equipment in
full compliance with all applicable OSHA, other
Federal, state, local codes, standards, and regu-
lations.
WARNING
Before performing maintenance or repair op-
erations on the machine, ensure that all power
has been removed and locked out to prevent
accidental start-up.
DO NOT assume that because the machine is
in a STOPPED condition that power has been
removed.
WARNING
DO NOT perform any modifi cations to this
equipment without prior factory approval.
WARNING
DO NOT use plastic pipe, or incorrectly rated
piping or hose. Incorrectly rated connection
material can fail and cause injury or equipment
damage.
WARNING
DO NOT operate the machine in enclosed or
confi ned spaces where ventilation is restricted
or closed off .
NOTE
Install electrical components (circuit breakers,
pressure switches, toggle switches, etc.) in
locations where exposure to water or moisture
will be most minimized.
NOTE
In order to prevent accidental damage to vehi-
cle components (fuel tanks, lines, brake lines,
wiring harnesses), note their location before
drilling any holes.
To Next Page
Loading...