Vanair Goodall CAP-START - Table of Contents

TABLE OF
CONTENTS
TABLE OF CONTENTS
090189-OP_r0 (JUNE-2022) TOC - I
VANAIR MANUFACTURING, INC.
(844) VAN-SERV • www.vanair.com
Cap•Start Hydraulic-Driven
12V/24V • Battery Starter • Charger
WARRANTY .................................................................. BEHIND COVER
TABLE OF CONTENTS ................................................................ TOC - I
WARRANTY CLAIMS PROCEDURE ..............................WARRANTY - I
CLAIMS PROCESS FOR WARRANTED PARTS ................................................WARRANTY - I
PROCEDURE ......................................................................................................WARRANTY - I
Figure W-1: Machine Serial Plate / Serial Number Location .........................WARRANTY - I
SECTION 1: SAFETY ................................................................. 1 - 1
1.1 GENERAL INFORMATION ..................................................................................... 1 - 1
1.2 DANGERS, WARNINGS, CAUTIONS AND NOTES ............................................... 1 - 1
1.3
SUMMARY OF DANGERS, WARNINGS AND CAUTIONS .................................... 1 - 1
1.3.1 DANGERS ....................................................................................................... 1 - 1
1.3.2
WARNINGS ..................................................................................................... 1 - 1
1.3.3 CAUTIONS ...................................................................................................... 1 - 2
1.4 SAFETY DECALS .................................................................................................... 1 - 2
1.5
CALIFORNIA PROPOSITION 65 WARNINGS ........................................................ 1 - 3
1.6 DISPOSING OF MACHINE FLUIDS ........................................................................ 1 - 3
SECTION 2: SPECIFICATIONS ....................................................... 2 - 1
2.1 GENERAL INTRODUCTION ........................................................................................ 2 - 1
TABLE 2A: SPECIFICATIONS FOR CAP•START HYDRAULIC MACHINE ......................... 2 - 1
TABLE 2B: CAPSCREW TIGHTENING TORQUE VALUES ................................................. 2 - 1
Figure 2-1: Machine Main Component Locations ........................................................... 2 - 2
SECTION 3: INSTALLATION ........................................................... 3 - 1
3.1 MACHINE PACKAGE RECEIPT/INSPECTION ........................................................... 3 - 1
3.2 GENERAL INSTRUCTIONS ......................................................................................... 3 - 1
3.3 DETERMINING THE MACHINE MOUNTING LOCATION ........................................... 3 - 2
Continued on next page...