Pressure circuit: Safety warning
Danger of burns!
When servicing an active pressure circuit, you should use necessary safety
equipment. (Gloves, goggles, etc.).
Be sure to read the user manual safety recommendations!
Proper operation of the unit in pressure mode is possible only if:
• The pressure circuit is clean.
• The core probe is in good working condition, no measuring point is defective!
• The pan thermocouple is in good working condition.
Never bypass a safety device, do not change the safety chain or the pressure
measurement circuit. Always use original parts.
XI.03
v03 • July-2016 • Hen
Pressure Module
Line Units Serial number (starting from) Sw Revision
VCCM
VCCWE
To Next Page
Loading...