Service messages
Principle and description
Description
Service messages are divided into three groups.
●Series100
Concerns all messages related to temperature
measurements.
●Series200
Concerns all messages related to the sensors
and actuators.
●Series300
Unused for now
●Series400
All messages related to communication problems
and software.
Principle
Under certain conditions the device can
detect operating or measurement errors. It
can then notify the user or the technician.
This is to facilitate troubleshooting.
In this module we list all the possible service
messages as well as their diagnosis. However the
diagnoses proposed below are not exhaustive.
A breakdown can have several reasons, it is not
possible to list them all.
Some service messages may require action so
that the unit recognises that the corresponding
sensor (or actuator) is back in working condition.
XIII.03
v03 • July-2016 • Hen
Service message module
Line Units Serial number (starting from) Sw Revision
VCCM
VCCWE
All ExxXH1009xxxxxxx 01-00-08
To Next Page
Loading...