INSTALLATION
Series 613
44/149
Edition 12.08.2022 984360EC
5.12.4.5 Error Codes
Code Error text Description
00 no error no error
0C wrong command length wrong command length
1C value too low value out of range: lower then min limit
1D value too high value out of range: higher then max limit
20
resulting zero adjust offset value out of
resulting zero adjust offset value out of range
21 not valid because no sensor enabled not valid because no sensor enabled
50 wrong access mode wrong access mode
51 time out
6D EEProm not ready
6E wrong parameter ID wrong parameter ID
6F set to default value not possible set to default value not allowed
70 parameter not settable set value not allowed
71 parameter not readable get value not allowed
72 set to initial value not possible initial value not allowed
73 wrong parameter index wrong parameter ID index (array)
74 initial value out of range wrong initial value
76 wrong value wrong value within range
77 wrong value, only reset possible only value reset possible
78 not allowed in this state not allowed in this state
7A wrong service service (action) not valid
7B parameter not active parameter is inactive
7C parameter system error parameter system error
7D communication error communication error (e.g. buffer overrun)
7E unknown service
7F unexpected character
80 no access rights
81 no adequately hardware
82 wrong object state
84 no slave command
85 command to unknown slave
87 command to master only
88 only G command allowed
89 not supported
A0 function is disabled
A1 already done
To Next Page
Loading...
