Series 613 INSTALLATION
984360EC Edition 12.08.2022 65/
Errors
Description Error message
Protocol
Parity error E:000001
Input buffer overflow (to many characters) E:000002
Framing error (data length, number of stop bits) E:000003
Overrun (Service interface: Input buffer register overflow) E:000004
Commands
CR or LF missing E:000010
: missing E:000011
Invalid number of characters (between : and ) E:000012
Invalid value E:000023
Value out of range E:000030
Hardware
Pressure mode, Zero or Learn without Sensor E:000040
Command not applicable for hardware configuration E:000041
Setup
ZERO disabled E:000060
Device Status
Command not accepted due to local operation E:000080
Command not accepted, Service Interface locked E:000081
Command not accepted due to synchronization, CLOSED or OPEN by digital input, safety mode or fatal error E:000082
Not accepted calibration and test mode E:000089
To Next Page
Loading...
