VAT 650 Series - Page 88

Installation, Operating & Maintenance Instructions
Series 650 DN 100-250 (I.D. 4“ - 10”), CC-Link
VAT Vakuumventile AG, CH-9469 Haag, Switzerland
Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com
280672EB
2010-12-15
88/94
Description Required tool
1. Reassemble the controller panel
(see steps 6…3).
Open end wrench 10mm
2. Tighten female screw locks from
POWER and SENSOR connectors with
1.1 Nm
(see step 2)
Open end wrench 4.5 mm
3. Tighten panel screws with 1.1 Nm
(see step 1)
Pozidriv screw driver
size 1