EasyManua.ls Logo

VDO MAP 7w Plus GPS - Routes Management

VDO MAP 7w Plus GPS
120 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
29
User Manual
It is also possible to delete all stored Routes and Waypoints:
[MENU] + [MENU] + "ROUTE" + [ENTER] + "CLEAR ALL" + [ENTER] + "YES"
+ [ENTER]
Following a Route (Activate the Navigation)
With the Route shown on the Chart page, move the cursor to the Waypoint in the
Route and press [ENTER], select "GOTO" and press [ENTER] again. The
destination is placed on the Waypoint of the selected Route and you are now
navigating to it.
Inserting Waypoint
To insert a new Waypoint between two existing ones, if a destination is not placed
on the Route:
Place the cursor on the desired Route leg + [ENTER] + "INSERT" + [ENTER]
+ move the cursor to the new position + [ENTER]
The new Waypoint is placed.
To add a new Waypoint to the last Waypoint of the Route:
Place the cursor + [ENTER] + "WAYPOINT" + [ENTER]
Reversing Route
To allow a return Route to be generated from an existing Route.
[MENU] + [MENU] + "ROUTE" + [ENTER] + "INVERT" + [ENTER]
The Route is then followed in reverse order, with Waypoints renumbered accord-
ingly. If the destination is placed on the Route, that Route cannot be reversed.
Selecting Route Report page
To give information on Waypoints belonging to the selected Route:
[MENU] + [MENU] + "ROUTE" + [ENTER] + "REPORT" + [ENTER]
In this page it is possible to modify the Speed and Fuel consumption values:
[MENU] + [MENU] + "ROUTE" + [ENTER] + "REPORT" + [ENTER] + "SPEED"/
"FUEL" + [ENTER] + use the cursor to insert values + [ENTER]
Sending/Receiving Route
E
To send the active Route to a external device capable of listening to NMEA RTE
and WPL sentences.
[MENU] + [MENU] + "ROUTE" + [ENTER] + "SEND" + [ENTER]
To receive Route from an external device capable of sending NMEA RTE and WPL
sentences. The Route is stored in the location of currently selected Route.
[MENU] + [MENU] + "ROUTE" + [ENTER] + "RECEIVE" + [ENTER]
Safe Route Checking
This function checks the presence of particular cartographic objects (see the list
below) on a range set by the user for all Route legs:
Land Areas
Shallow Water
Intertidial Areas
Rocks
Wrecks
Obstructions
Shoreline Constructions
Fishing Facility
Dredged Areas
Diffusers
Mooring/Warping Facility

Table of Contents

Related product manuals