EMR3 Truck Installation Installation Procedures - Fuel Oil Truck Application
7
Figure 2. Remove adjustor dust cover plate
Figure 3. Installing meter encoder adapter coupling
Remove two screws to
remove dust plate cover
emr\lc meter dust plate.eps
START
FINISH
MODE PRESET
NEXT
ENTER
VOLUME CURRENCY RATE SETUP
Cover
O-ring P/N 512700-242
Groove pin
P/N 510162-001
EMR 3
Encoder
Shaft
Hex Drive
(with protruding
pins opposite
sides)
Hex
Drive
Vertical
drive
shaft
Shaft - spade
drive short LC
P/N 328907-001
Coupling shaft
P/N 331413-001
Sleeve - coupling shaft
P/N 331955-001
Coupling shaft
P/N 331413-002
emr\lc meter adjuster.eps
As required
To Next Page
Loading...
