Veeder-Root EMR3 - Page 21

EMR3 Truck Installation Installation Procedures - Fuel Oil Truck Application
16
Figure 11. Calibrator, spring assembly, and meter dome adapter
Figure 12. Adapter shaft and groove pin for Smith meter
Calibrator
If distance from face
to top of calibrator
support flanges = 0.850" (21.59 mm
),
use shaft group 331433-002;
if distance = 0.635" (16.13 mm),
use shaft group 331433-001
Spring
assembly
Meter dome adaptor
emr/smith4.eps
0.68 (17.27)
0.09
(2.29)
0
.186
(
4.72)
0.15
(3.81)
B
0.373 (9.47)
Short Shaft 2.208 (56.08) 1.528 (38.81) 331433-001
Long Shaft 2.423 (61.54) 1.743 (44.27) 331433-002
A
510119-002 Groove Pin
(Factory Installed in "TOP" End)
7/64 (2.77)
Diameter
through hole
5/64 (1.98)
Diameter
through hole
emr\smith2.eps
AVersion Shaft Grou
p
B
"TOP"
mm in parentheses