12-7
12 Volumetric Line Leak Detection Last Annual Test Passed
Last Annual Test Passed
If necessary, press STEP until you see the message:
Use this display to enter the date of the last annual test passed.
NOTE: This message only appears if “Annual Warning” was enabled in System Setup.
To enter the date of the last annual test passed, press CHANGE and enter the date. Press ENTER to confirm your
entry:
Setting Up Additional Line Leak Detectors
If you have additional Line Leak Detectors to set up, press STEP to return to the ENTER PIPE LABEL message:
Press TANK/SENSOR to access a new Line Leak Detector. Repeat the steps described above beginning with
“Pipe Label and Tank Identification” on page 12-1.
If you have entered setup information for all Volumetric Line Leak Detectors in the system, press FUNCTION to
exit.
LAST ANNUAL TEST PASSED
DATE: XX/XX/XXXX
DATE: XX/XX/XXXX
PRESS <STEP> TO CONTINUE
To Next Page
Loading...
Need help?
General
