EasyManua.ls Logo

Veeder-Root TLS-350 - Liquid Sensor Location; Liquid Sensor Type

Veeder-Root TLS-350
227 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18 Liquid Sensor Setup Liquid Sensor Location
18-2
Press STEP. If more than one module is installed, the system automatically advances to the SENSOR CONFIG
message for the next module. Up to 8 modules may be installed. Repeat the steps described above for each
module until you have entered the configuration information (sensor positions) for all modules and the system
displays the ENTER SENSOR LOCATION message.
Liquid Sensor Location
If necessary, press STEP until you see the message:
To enter the location of a liquid sensor, press TANK/SENSOR repeatedly until the sensor you want appears on
the second line of the message (L1, L2, L3, etc.). Press CHANGE and enter the location (up to 20 alphanumeric
characters) of the selected sensor. Typical entries would be: INTERSTITIAL TANK 1; SUMP TANK 1, etc. (This
information will appear on sensor status and sensor alarm reports to make it easier to identify the location of
alarms.) Press ENTER to confirm your entry:
Press STEP to continue.
Liquid Sensor Type
If necessary, press STEP until you see the message:
If necessary press CHANGE to display additional liquid sensor types (see table below):
Sensor Type Entry Applicable V-R Sensor V-R Part Number
Tri-State (Single Float) Sump sensor 794380-208
Steel Tank sensor 794390-420, 794390-460, 794380-333
Fiberglass Interstitial Float sensor 794390-401, -404, -407, -409
Position-Sensitive sensor 794380-323
Steel Tank sensor - Stainless Steel 794380-430
Mini-Hydrostatic, Single Point sensor 794380-304
Normally Closed None None
Dual Float Hydrostatic Dual Point Hydrostatic sensor 794380-302 (soon to superseded by 794380-303)
Dual Float Discriminating* Discriminating Pan sensor 794380-322
Discriminating Sump sensor 794380-352
Dual Float High Vapor Discriminating Pan sensor 794380-322
Discriminating Sump sensor 794380-352
Interceptor (European - limited to
certain specific Interceptor types)
Interceptor sensor 720-000-1000
*For Oil/Water Separator sensors (P/N 794690-XXX) use Dual Float Discriminating for sensor type.
ENTER SENSOR LOCATION
L1:
L1: (Sensor Location)
PRESS <STEP> TO CONTINUE
L1: ENTER SENSOR TYPE
TRI-STATE (SINGLE FLOAT)

Table of Contents

Other manuals for Veeder-Root TLS-350

Related product manuals