5 System Setup Selecting the System Setup Function
5-2
To print a Setup Data Report, press the MODE key to display the Setup Mode main screen (see below), then
press the PRINT key.
Selecting the System Setup Function
Press MODE to select the Setup Mode, then press FUNCTION until you see the message:
Press STEP to continue.
System Language
If necessary, press STEP until you see the message:
Once you choose a language, the system displays and prints all information in that language. Available language
choices depend on the language set specified when the system was ordered. The available language sets are:
• English/Dutch • English/French • English/Finnish
• English/German • English/Greek • English/Italian
• English/Japanese • English/Polish • English/Portuguese
• English/Russian • English/Spanish • English/Swedish
• English/Turkish
To choose English, press STEP. (The system displays the SYSTEM UNITS message.) NOTE: When using the
English/Japanese language set with a remote printer, you must set the printer’s data bit-per-character switch to 8
bits.
To choose an alternate language, press CHANGE, in response to the SYSTEM LANGUAGE message, and press
ENTER. The system displays the message:
Press STEP to continue.
System Units
If necessary, press STEP until you see the message:
SETUP MODE
PRESS <FUNCTION> TO CONT
SYSTEM SETUP
PRESS <STEP> TO CONTINUE
[Selected Language]
PRESS <STEP> TO CONTINUE
To Next Page
Loading...
Need help?
General
