5-29
5 System Setup System Beeper
The Inventory Alarms and selectable threshold configurations are listed in Table 5-2 below:
Press STEP to continue, or press CHANGE until the appropriate units selection appears, then press ENTER to
confirm the entry.
If Custom is selected then you can change one or more of the five Inventory Alarms to one of the selectable units.
Press CHANGE to select a different unit for this alarm or press ENTER to confirm the selection, then press STEP
to continue to the next Inventory Alarm. Repeat this sequence to change the remaining four Inventory Alarms.
Press STEP to continue.
System Beeper
If necessary, press STEP until you see the message:
If you want to disable the console beeper, press CHANGE:
Press ENTER:
Table 5-2. Configurations For Setting Inventory Alarm Thresholds
Inventory Alarm
Threshold Configuration
Standard All %Full All Volume All Height Custom
Max or Label Volume %Full Volume Height %Full, Vol, or Ht
High Product %Max %Full Volume Height %Max %Full,Vol,or Ht
Overfill %Max %Full Volume Height %Max %Full,Vol,or Ht
Delivery Needed %Max %Full Volume Height %Max %Full,Vol,or Ht
Low Product Volume %Full Volume Height %Max %Full,Vol,or Ht
INVENTORY ALARM CUSTOM
MAX OR LABEL: %FULL
DISABLED
PRESS <STEP> TO CONTINUE
To Next Page
Loading...
Need help?
General
