5-3
5 System Setup Setting the Date and Time Format
You can set the system units to U.S. units (gallons, gal/hour, inches, F), metric units (litres, litres/hour, millimeters,
C), or imperial gallons (imperial gallons, imp. gal/hour, inches, F). If the HRM feature was enabled (see “TLS-350
Consoles” on page 4-1), the default units will be metric.
NOTE: If you change the System Units after entering other quantitative setup values, the system converts values to
the new units. The Date format also changes according to your selection of System Units.
To choose U.S. units, press STEP. (The system displays the SET DATE message.)
To choose metric, press CHANGE in response to the SYSTEM UNITS message and press ENTER. To choose
imperial gallons, press CHANGE twice in response to the SYSTEM UNITS message and press ENTER. The
system confirms your choice with the message:
Press STEP to continue.
Setting the Date and Time Format
If necessary, press STEP until you see the message:
To accept the format shown, press STEP. (The system displays the SET TIME message).
Available date/time formats are:
• MON DD YYYY HH:MM:SS (APR 01 2002 10:02:30)
• MM-DD-YY HH:MM:SS xM (04-01-02 10:02:30 AM); xM is AM or PM
• MM-DD-YY HH:MM:SS (04-01-02 10:02:30)
• DD-MM-YY HH:MM:SS (01-04-027 10:02:30)
• YY-MM-DD HH:MM:SS (02-04-01 10:02:30)
Press CHANGE until the desired format is shown, then press ENTER. Press STEP to continue.
Current Date
If necessary, press STEP until you see the message:
To accept the date shown, press STEP. (The system displays the SET TIME message).
To change the date shown, press CHANGE, enter the correct date by first entering the month then the day then
the year following the format shown on the display, then press ENTER. The system confirms your entry with the
message:
Press STEP to continue.
[Selected Units]
PRESS <STEP> TO CONTINUE
SYSTEM DATE/TIME FORMAT
MON DD, YYYY HH:MM:SS xM
SET: MONTH DAY YEAR
DATE: XX/XX/XXXX
DATE: XX/XX/XXXX
PRESS <STEP> TO CONTINUE
To Next Page
Loading...
Need help?
General
