5-11
5 System Setup Line Annual Test Needed Warnings
or conducted in a specified number of days (0 to 30), and activate an alarm if a test has not been passed after a
warning, or a specified number of days.
ENABLE LINE PERIODIC TEST NEEDED WARNINGS AND ALARMS
To enable Line Periodic Test Needed Warnings, press CHANGE, ENTER, then STEP. The system displays the
message:
Press CHANGE, and enter the number of days (0 to 30 days) after which you want the system to warn that a
periodic line test has not been passed. Press ENTER. The system displays the message:
Press STEP. The system displays the message:
Press CHANGE, and enter the number of days (0 to 30) after which you want the system to alarm if a test has not
been passed. This number should be higher than the number you set for the warning. Press ENTER. The system
displays the message:
Press STEP. (The system displays the Line Annual Warnings message.)
DISABLE LINE PERIODIC TEST NEEDED WARNINGS
To disable the line periodic warnings, press CHANGE in response to the Line Periodic Test Needed Warnings
Enabled message. The system now displays:
Press ENTER. The system confirms your choice with the message:
Press STEP to continue. (The system displays the Line Annual Test Needed Warnings message.)
Line Annual Test Needed Warnings
If necessary, press STEP until you see the message:
LINE PER TST NEEDED WRN
DAYS = XXX
DAYS = XXX
PRESS <STEP> TO CONTINUE
LINE PER TST NEEDED ALM
DAYS = XXX
DAYS = XX
PRESS <STEP> TO CONTINUE
LINE PER TST NEEDED WRN
DISABLED
DISABLED
PRESS <STEP> TO CONTINUE
LINE ANN TST NEEDED WRN
DISABLED
To Next Page
Loading...
Need help?
General
