5-17
5 System Setup QPLD Monthly Printout - International Option
QPLD Monthly Printout - International Option
When the HRM feature is enabled (see “TLS-350 Consoles” on page 4-1), QPLD is automatically enabled and it
will print out a report once a month. If this report is not required it may be disabled as follows.
Press STEP to display the message:
Press CHANGE to disable the report, then press ENTER.
Euro Protocol Prefix
This feature is for European applications only. If necessary, press STEP until you see the message:
Accept the default S for the standard Euro Protocol command response prefix. Press CHANGE, then ENTER, to
select d which is a special Euro Protocol command prefix.
BDIM Trans Alarm Delay
If necessary, press STEP until you see the message:
BDIM Transaction Alarm Delay is available only if there is a Block DIM card installed in the console. This feature
lets you enter a delay (of from 5 to 999 hours) before posting a Block DIM Transaction Alarm. Press CHANGE,
enter the desired delay, then press ENTER to confirm your choice. Enter 000 to disable this feature.
System Security Code
If necessary, press STEP until you see the message:
The System Security Code is a 6-digit numeric code which should be known only to personnel responsible for the
setup, management, and service of the system. If you enable the System Security Code, you will be required to
enter this code before you can access any setup or diagnostic function.
If you do not want to enable the Security Code, the system setup is complete. Press FUNCTION to exit the
System Setup function or press STEP to return to the SYSTEM LANGUAGE message.
To enable the System Security Code:
1. Follow the Security Code Enable/Disable procedure in the previous section to make the required DIP switch
enable settings,
QPLD MONTHLY PRINTOUT
ENABLED
BDIM TRANS ALARM DELAY
HOURS: 024
SYSTEM SECURITY
CODE: 000000
To Next Page
Loading...
Need help?
General
