5 System Setup Custom Alarm Labels
5-20
• LED: Turn on the front panel Warning or write in your new label in the Custom Alarm Label column of Table 5-1.
When you have completed your custom alarm label entries, press the PRINT key while in System Setup, to print
out a copy of your changes.
To continue, press ENTER:
Press CHANGE:
Press ENTER:
Press STEP to continue:
Press CHANGE and ENTER to access available System Alarms, or STEP to move through the alarm sets: In-Tank
alarms, Liquid Sensor alarms, etc. When making changes, standard setup entry procedures apply - you can
designate a single device or all devices for the label change. After each custom label entry, you then select enable
or disable for each of the four console alarm indicators assigned to that custom alarm: LCD, Print, Beep, and LED.
CUSTOM ALARM LABELS
DISABLED
CUSTOM ALARM LABELS
ENABLED
ENABLED
PRESS <STEP> TO CONTINUE
CUSTOM ALARM LABELS
SYSTEM ALARMS : NO
To Next Page
Loading...
Need help?
General
