1
Introduction
This manual describes the site preparation and console installation procedures for the TLS-HLD Console.
This manual assumes that you installing the TLS-HLD in a new site (before pavement is put down and with no wiring
runs in place). Among the topics covered are:
• Site layout considerations.
• Installing the console and connecting wiring from the 120 or 240 Vac power panel.
• Probe assembly and installation procedures.
• Installing wiring conduit between the console and its probes.
• Probe-to-console field junction box wiring diagram.
• Attaching probe wiring to the console.
• RS-232 serial communication connection requirements and serial commands.
• Troubleshooting information that contains diagnostic and maintenance information.
• System specifications.
After the console is wired to its power source and probes, you should program the console following the setup
instructions contained in the TLS-HLD Setup manual.
Regulatory Agency Console Documentation
The UL Console Form Numbers are listed by Underwriters Labs, in File Number: MH11766.
Related Manuals
577013-785 TLS-HLD Setup manual
576013-635 RS-232 Serial Interface manual
576013-859 Direct Burial Cable Installation manual
To Next Page
Loading...
Need help?
General
