If you have two remote controls with dierent products
registered in them, you can copy the contents from one to
the other and vice versa. Then all products can be oper-
ated with both remote controls.
The example shows how to copy the products from re-
mote control A to remote control B and at the same time
maintain the settings and the programs of both remote
controls.
Step 1: Change security key in remote controls A and B
Change the security key in both remote controls so that
they have the same security key, see section Security key.
Step 2: Register the products in remote control A
Register all products in remote control A by choosing:
If in doubt, see section Registering new products.
Remote control A can now operate both the products
from remote control B and the products it could already
operate.
Step 3: Register the products in remote control B
Register all products in remote control B by choosing:
Remote control B can now also operate both the products
from remote control A and the products it could already
operate.
After this both remote controls can operate all products.
Copying to a remote control in operation
To Next Page
Loading...
