Initial set-up
Products to be operated with the remote control must be
registered in the remote control. Registration, however,
depends on whether the remote control is new or whether
it is already used for operating other products.
1
•Iftheremotecontrolisalreadyinoperation,proceed
with section Registering new products.
•Iftheremotecontrolisnew,proceedasfollows.
When the initial set-up has been completed, the registered
products will appear in the display.
2
Slide o the battery cover of remote control as shown.
Insert the three batteries supplied (type AA, 1.5 volt).
Replace cover.
3
Choose language:
P ress
to highlight your language.
Press "Enter" to confirm your choice.
4
Prepare products for registration.
Disconnect the main power supply to the products for
1 minute and then reconnect it. The products can now be
registered in the remote control within the next 10 min-
utes.
To Next Page
Loading...
