4
When the skylight is closed, press with a pointed
object through the operator cover hole marked A for
at least 5 seconds. The skylight operator and other
electrical products connected to the skylight will run
briefly back and forth indicating that they are ready to
be registered.
5
To reinstate the connection between skylight and
remote control, register the skylight with its electrical
products in the remote control again. Please refer to
the instructions in section Initial set-up or Registering
new products.
N o t e : The same procedure applies to a change of
opening from in-reach to out-of-reach applications.
To Next Page
Loading...
