EasyManua.ls Logo

Vendo VUE 40 - Page 115

Vendo VUE 40
141 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TC Failed
Movement
( Test
Configuration
failed Movement)
1.When one of the
movements in X , Y ,
Z or Clamp fai
l during
Test Motors.
2. When one of the
sensors fails. ( eg.
X,Y, Z , Clamp or
Forward Looking
Optics Sensors )
1.Check to see if the X , Y , Z or Clamp
movements are performing normally. On Exit
from Test Motors the X,Y, Z and clamp should
be in the home position.
2.Check the Sensors. ( O denotes a good
sensor. If the sensor is blocked - then change
the respective sensor )
Service Mode: Test Motors - Sensor Status
Check X, Y, Z, C and F. Refer to Programming Sction
of the GFV Manual for Sensor Status Readings.
Vending Mechanism - VMC Error
Check the Hopper flap harness connection. Run Test Hopper Flap in Test Mode Hop.Flap No
Current
Hopper flap motor
either did not run, or,
no current was
detected.
If motor moves, current detection circuitry has been
damaged on VMC.
Replace VMC board.
Run Test Hopper Flap in Test Mode
If motor does not move, replace Hopper Flap motor.
Hopper Flap Jam
VMC (Main
Controller) detected
high current while
running the Hopper
Flap motor. It did not
detect the Hopper
flap positioning
switch.
Check to see if product is jamming the Flap Remove the product.
Run Test Hopper Flap in Test Mode
Check Hopper Bucket harness connection. Disconnect then reconnect Hopper Bucket Harness
Run Test Hopper Bucket in Test Mode
Hop.Buck No
Current
(Hopper Bucket
no current)
Hopper Bucket Motor
either did not run, or
did not detect any
current.
Run Test Hopper Bucket in Test Mode
If motor moves, the current detection circuitry has been
damaged on VMC. Replace VMC board.
Run Test Hopper bucket in Test Mode If motor does not move, replace Hopper Bucket motor.
Hopper Buck Jam
VMC (Main
Controller) detected
high current while
running the Hopper
Bucket.
Check to see if product is jamming the Bucket Remove the product. Run Hopper Bucket Test.
Hopper Flap
Switch
Hopper flap motor
runs but does not
detect the home
switch.
Run Test Hopper Flap in Test Mode Replace hopper flap motor assy.

Other manuals for Vendo VUE 40

Related product manuals