Vendo VUE 40 - Page 121

"Calibration -
Dscv 2 in
progress ..
Please wait" -
but
the vendor
remains idle.
Electronics could not
complete Discovery
2.
POWER ON The 'physical' stop made by the Y-
Rail is at a lower position to the Y-
Home sensor
then it should be. **Note - the PDC does not
slide down further once it stops.
Calibration Discovery Mode: Manually perform a
discovery 2.The machine should scan the left side of
the tray and then the right side of the tray. Once the
hand finishes the left scan, the PDC will move to the
home position and stop. The rail should not stop and
slid.Adjust the physical stop so that it holds the rail in
place. Please refer to Y-home adjustment.
"Auto Recovery
Failure… Please
wait" - but the
vendor remains
idle.
Electronics could not
complete the initial
startup routine.
Service Mode: Diagnostics - check the error
code displayed.
POWER DOWN. Wait 5 seconds, POWER ON.
Perform Calibration 2 Discovery in Service Mode.