SAFETY
Safety - 14
General Safety Procedures
for Ventrac Power Units, Attachments, & Accessories
• Remove the machine from the truck or trailer and refuel it on the ground. If this is not possible, refuel the
machine using a portable container, rather than from a fuel dispenser nozzle.
• Never remove the fuel cap or add fuel with the engine running. Allow the engine to cool before refueling.
• Never remove the fuel cap while on a slope. Only remove the fuel cap when parked on a level surface.
• Replace the fuel tank cap and the container cap securely.
• Do not overll the fuel tank. Only ll to the bottom of the fuel neck, do not ll the fuel neck full. Overlling
of the fuel tank could result in engine ooding, fuel leakage from the tank, and/or damage to the emissions
control system.
• If fuel is spilled, do not attempt to start the engine. Move the power unit away from the fuel spill and avoid
creating any source of ignition until the fuel vapors have dissipated.
• If the fuel tank must be drained, it should be drained outdoors into an approved container.
• Check the fuel lines for tightness and wear on a regular basis. Tighten or repair them as needed.
• The fuel system is equipped with a shut-o valve. Shut o the fuel when transporting the machine to and
from the job, when parking the machine indoors, or when servicing the fuel system.
Hydraulic Safety
• Make sure the hydraulic connections are tight and all hydraulic hoses and tubes are in good condition. Re-
pair any leaks and replace any damaged or deteriorated hoses or tubes before starting the machine.
• Hydraulic leaks can occur under high pressure. Hydraulic leaks require special care and attention.
• Use a piece of cardboard and a magnifying glass to locate suspected hydraulic leaks.
• Keep your body and hands away from pinhole leaks or nozzles that eject high pressure hydraulic uid. Hy-
draulic uid escaping under high pressure can penetrate the skin causing serious injury, leading to severe
complications and/or secondary infections if left untreated. If hydraulic uid is injected into the skin, seek
immediate medical attention no matter how minor the injury appears.
• The hydraulic system may contain stored energy. Before performing maintenance or repairs on the hydrau-
lic system, remove any attachments, engage the parking brake, disengage the weight transfer system (if
equipped), shut o the engine, and remove the ignition key. To relieve pressure on the auxiliary hydraulic
system, shut o the power unit engine and move the hydraulic control lever left and right before disconnect-
ing the auxiliary hydraulic quick couplers.
https://www.tractormanualpdf.info/
To Next Page
Loading...
