Testing the Headlight Switch
1. Park the machine on a level surface, lower any attachments to the ground,
engage the parking brake, and remove the key from the ignition.
2. Switch the main circuit breaker to the O
FF position, to de-energize the electrical
system.
3. Remove the control panel from the right seat box; refer to Removing and
Installing the Control Panel, page 7–19.
4. Identify the headlight switch and disconnect the wire harness connector from the
switch, remove the switch from the control panel if necessary.
5. Use a multimeter (ohms setting) and the preceding table to determine whether
continuity exists between the terminals for each switch position.
6. Replace the switch if necessary.
7. If the switch tests correctly and a circuit problem still exists, check the wire
harnesses; refer to 9 Appendix A, page 9–1.
8. Install the switch, connect the wire harness, and install the control panel after
testing.
9. Switch the main circuit breaker to the O
N position, to energize the electrical
system.
Directional Signal Switch
POSITION CLOSED CIRCUITS
G423559
RIGHT SIGNAL ON 8 + 9
OFF NONE
LEFT SIGNAL ON 3 + 2
The directional signal switch is located on the control panel. Pushing down on the top
of the switch turns on the right directional signal lights. Pushing down on the bottom
of the switch turns on the left directional signal lights. Putting the switch in the middle
position turns off the directional signal lights.
4520Z Page 6–33 Electrical System: Headlight Switch
09.40001Rev 00
To Next Page
Loading...
