Removing the Center Pivot
Figure 112
G445370
SDLA linkage
Mounting bolts
Cotter pin
Castle nut
1. Remove any attachments from the machine, park the machine on a level surface,
engage the parking brake, remove the key from the ignition, and switch the circuit
breaker to the O
FF position.
2. Remove the hydraulic pump cover; refer to Removing and Installing the Hydraulic
Pump Cover, page 7–15 and the lower frame cover; refer to Removing and
Installing the Lower Frame Cover, page 7–18.
3. Remove the front / rear connector link; refer to Removing the Front / Rear
Connector Link, page 7–46.
CAUTION
The machine is very heavy, and a hoist that is not rated for the weight of the
machine may fail, causing possible injury and damage to the machine.
Use hoist equipment rated to lift the machine safely.
4. Support the front of the machine using a hoist.
5. Disconnect the SDLA linkage
from the hydraulic pump control arm.
Chassis: Service and Repairs Page 7–48 4520Z
09.40001Rev 00
To Next Page
