SETUP
Installing or Replacing MSAM, Micro SD and SIM Cards
16 V200T INSTALLATION GUIDE
3 Remove the clear protective film from the display.
4 Replace all the packing materials, close the lid, and save the carton for
repacking or moving the V200t unit in the future.
Installing or
Replacing
MSAM, Micro SD
and SIM Cards
You may need to install or replace the Multiple Security Access Module (MSAM),
Micro Secure Digital (SD) and Subscriber Identity Module (SIM) cards.
Opening Card
Compartment
Use the following steps to get access to the MSAM, Micro SD and SIM card
compartments:
1 Place the terminal face down on a soft and clean surface to protect the display
from scratches.
2 Push the locking tab and swing out the compartment cover.
3 If it’s already installed, remove the battery (VPN BPK470-001-01-A) to get
better access to the card slots
Figure 5 Accessing Cardholders
4 The MSAM, Micro SD and SIM cardholders are now accessible.
Do not use a unit that has been tampered with or otherwise damaged. This unit
comes equipped with tamper-evident label. If a label or component appears
damaged, immediately notify the shipping company and your Verifone
representative or service provider.
Observe standard precautions in handling electrostatically sensitive devices.
Electrostatic discharges can damage the equipment. Verifone recommends using
a grounded anti-static wrist strap.
To Next Page
Loading...
