VeriFone V200t - Connecting Optional Devices

SETUP
Connecting Optional Devices
V200
T INSTALLATION GUIDE 21
6 Swing the paper roll cover until it clicks shut, allowing a small amount of paper
(past the glue residue) to extend outside the printer door.
Figure 12 Closing Printer Door
Connecting
Optional
Devices
The V200t device supports some peripheral devices designed for use with
electronic point-of-sale terminals.
Different terminals support different devices, so for more information about
optional devices, please contact your Verifone distributor.
Optional Device
Connections
You can connect several devices to your V200t. You can use the following cables
for different types of device connections:
• RJ9 to DB9 cable (VPN CBL000-051-02-A)
• Multi-port coiled cable (VPN CBL470-006-02-A)
Contact your Verifone representative or visit the online store at
www.store.verifone.com for information on these devices.
CAUTION
Before connecting any peripheral device, remove the power plug from the
terminal. Reconnect the power cord only after you are finished connecting the
peripheral device(s). For complete information about peripheral installation and
use, refer to the user documentation supplied with those devices.
NOTE
Make sure you replace the rear cover when all cables are installed. This provides
some protection to the cables and connectors. Do not carry the terminal by the
installed cables or pull the terminal about the by the cables. This may cause a
cable to be removed or damage the cables.
CAUTION
Some devices (ECRs and some PIN pads) require a separate power source.
Before connecting to any device, remove the power cord from the V200t unit.