VeriFone VX 520 Instruction Manual

ITCARD • Planet Cash • Planet Pay • Planet Plus
43
4.6.1.3 Connection test
FIGURE 10 DIAGNOSTICS - CONNECTION TEST
4.6.1.4 Reader test and PIN pad diagnostics
The test of the readers helps to ensure that card readers in the terminal and in the PIN pad are able to read the
card proper for their type (microprocessor, magnetic, contactless card).
In order to make the test of the readers:
FIGURE 57 DIAGNOSTICS – READERS’ AND PIN PAD TEST
When every read of the card is successful, the application switches to the subsequent test.
The lack of the reader reaction to the inserted, pulled or put card proper for the type of the reader means failure.
In such a case in order to switch to the subsequent test, press CANCEL.
7. The application
displays the question
about the test
connection. Select YES.
8. The application displays the authorisation HOST IP
ADDRESS obtained from the currently set parameter. If
need be, edit it, then confirm
Perform the same steps for the HOST PORT field.
10. The application
makes a connection and
displays the test result.
11. Pull the card through
the magnetic card
reader
12. Insert the card to the
microprocessor card
reader
13. Put the contactless
card against the CTLS
reader on the PIN pad
13. The application asks
about the PIN pad
diagnostics. Select YES
or NO

VeriFone VX 520 Specifications

General

Processor	400 MHz ARM11
Card Readers	Magnetic stripe, EMV chip
Operating Temperature	0°C to 50°C (32°F to 122°F)
Display	128x64 pixel backlit LCD
Connectivity	Dial-up, Ethernet
Contactless	Optional
Printer	18 lines per second
Security	PCI PTS 3.0 approved
Weight	500g
Dimensions	203 mm x 87 mm x 77 mm (8.0 in x 3.4 in x 3.0 in)