Vertical Express LD-16 - Separate Header Installation

LD-16 Door Operator - Modernization Existing Cab Header Installation
October 2021 - 88420 v.1.0
27
Existing Cab Header Installation
Strut
Door
Mounting
Angle
Header
Plate
Wiring Harness and CTS
Fixing Bracket
Door
LD-16 Door Operator
Single-Speed, RH shown
Clutch and Linkage
Rear Header Support
Junction
Box
End Clip
Overview
Installation Steps
1. Remove existing door operator
2. Install bottom strut
3. Install door mounting angle
4. Install header plate
5. Install header support
6. Install fixing brackets
7. Install LD-16 door operator
8. Install wiring harness and CTS
9. Install doors
10. Install clutch and linkage