What to do if the Vertical Express LD-16 Garage Door Opener hoistway door is not locked and the car door is closed?
If the Vertical Express Garage Door Opener's hoistway door latch doesn't lock due to closing force, wind, or dirt in the sill while the car door is closed, move the car door interlock/restrictor ramp in the Door Close direction.
General safety guidelines for working with elevator equipment, including power and wiring checks.
Guidelines for safe electrical practices, including proper fusing and avoiding shocks.
Safety precautions related to mechanical aspects of elevator operation and maintenance.
Safety considerations when working with the elevator's power unit fluid system.
Procedures for receiving and storing equipment to prevent static damage.
Best practices for handling electronic boards to prevent electrostatic discharge.
Guidelines for packaging and shipping electronic boards to maintain warranty.
Safety precautions and procedures for accessing and working on elevator car tops.
Specific safety measures to follow when performing work on elevator car tops.
Hazards and safety precautions associated with entering and working in elevator pits.
Detailed safety measures for working within elevator pits, including electrical and environmental hazards.
Introduction to integral cab header assemblies for door operators.
Information regarding the installation of door operators on existing cab headers.
Installation steps for the Universal MOD Kit for existing cab headers.
Instructions for setting the eccentrics on the car door hanger for alignment.
Wiring instructions for the door operator, including diagrams and connections.
List and descriptions of fault codes generated by the door operator system.
Guide to diagnose and resolve common problems with the door operator.
Instructions for setting up the serial interface board for communication.
Explanation of the LEDs on the serial interface board and their status.
Troubleshooting steps for issues with the serial interface board.
Troubleshooting guide for serial communication issues between systems.
Setup instructions for discrete controller interfaces in non-TAC systems.
Definitions of Input/Output signals for the discrete controller interface.
Wiring diagram for the Input/Output signals of the discrete controller.
Method for calculating minimum door closing times based on kinetic energy.
Procedure for replacing the door operator control board.
Instructions for replacing the drive belt of the door operator.
Details and diagrams for GAL Interlock Rollers clutch assemblies.
Details and diagrams for MAC Interlock Rollers clutch assemblies.
Details and diagrams for TKE Interlock Rollers clutch assemblies.
Information on Otis 6940 Interlock clutch assemblies.
Details for Westinghouse Interlocks Model E5A clutch assemblies.
Information on Westinghouse clutch assemblies, model 364AL_.
Diagrams for the COP Extension Harness (462AEN_) used with the operator.
Diagrams for the COP Adapter Harness (462AEM_) used with the operator.
Front view wiring diagram for the discrete controller.
Rear view wiring diagram for the discrete controller.
General| Brand | Vertical Express |
|---|---|
| Model | LD-16 |
| Category | Garage Door Opener |
| Language | English |
To Next Page