Electronic Setup & Adjustment LD-16 Door Operator - Modernization
58 © Vertical Express
Install Electronic Edge
(continued)
Figure 52 - Install Electronic Edge
Electronic Setup & Adjustment
Wiring See also: Job wiring diagrams and generic wiring diagrams starting on page A-16
(Appendix).
1. Verify that the doors are mechanically adjusted for smooth movement with no
binding or interference.
2. Remove the cover from the Door Operator Control Board. See Figure 53 on
page 59.
a. If required, move the car doors partially open.
b. Loosen 4 screws, slide the cover over and off of the screws, and set the cover
aside. The Door Operator Control Board should not have power at this point.
X15X16
Door Operator Control Board
To Next Page
Loading...