Vertical Express LD-16 - Serial Communication for TKE Legacy Control Systems; Serial Interface Board Setup

LD-16 Door Operator - Modernization Serial Communication for TKE Legacy Control Systems
October 2021 - 88420 v.1.0
71
Serial Communication for TKE Legacy Control
Systems
Serial Interface Board Setup
See also:
• Serial Interface Board LED Definitions on page 72.
• Serial Interface Board Troubleshooting Guide on page 72.
• Serial Communications Troubleshooting Guide on page 73.
Figure 59 - Serial Interface Board (6300AFM)
JP4
FRONT = OFF
REAR = ON
F1 Fuse
1/2 amp Pico
• JP1 = ON to apply a 121W CAN loading resistor to CON1.
• X1 Jumper on CAN Interface Board; set X1 = ON.
CAN port to CAN Interface Board
RS485 to Legacy
Control System,
connects to CON11
on Door Operator
Control Board.
To enable, set
D12/D13 = 8 (in
CPU).
24VDC Power Input
RST