Vertical Express LD-16 - Separate Header Installation

LD-16 Door Operator - Modernization Separate Header Installation
October 2021 - 88420 v.1.0
35
Separate Header Installation
1. Remove the following parts—Do Not Remove the Header Angle. See Figure 30.
• Door operator
• Tracks
• Hangers
Figure 30 - Remove Door Operator and Equipment—Do Not Remove the Header Angle(s)
2. Install the door operator mounting per the applicable application.
• Single-Speed: Figure 31 on page 36.
• Center-Opening: Figure 32 on page 37.
• Two-Speed: Figure 33 on page 38.
Do Not Remove the Header Angle(s)
Side View