To edit a receptacle:
1. Log in with the required privileges.
2. From the PDU Explorer tab, drill down to the receptacle to be edited by clicking on the rack PDU then the
branch with the receptacle.
3. Click on the receptacle to highlight it.
4. In the table at the bottom of the window, click the Settings tab.
5. Check the box or boxes next to the settings to be edited.
6. Click the Edit icon .
7. Enter the new values.
-or-
Use the drop-down menu to do one of the following:
• Enable or disable software overcurrent protection.
• Change whether the receptacle is designated critical or noncritical.
8. When finished, click the Save icon to make the change or click the Cancel icon to discard the change.
Vertiv | RPC2™ Communications Module Installer/User Guide | 15
To Next Page
Loading...
