Vertiv RPC2 - Factory Default Settings

Appendix C: Factory Default Settings
The following table displays the current factory default settings.
LEVEL SETTING DEFAULT VALUE
Settings
System Name System Name
Description Description
Contact Name Contact
Location Location
Temperature Display Celsius
SWOTPScope Local
SWOTPDelay (seconds) 10
Audible Alarm Enabled
Time Format 12 hour
Network
Speed/Duplex Auto (1000 Mbs/Full Duplex)
Host Name RPC2-551831G102C2015DEC150246
IPv4 DHCP
IPv6 DHCP
DNS
IPv4 Obtain DNSserver automatically
IPv6 Obtain DNSserver automatically
DNSTest Fully Qualified Domain Name
Time
External Time Source NTPServer
Time Server pool.ntp.org
Synchronize Rate Hourly
Messaging
Email Port 25
SMSPort 25
Consolidation Time (seconds) 60 (email and SMS)
Consolidation Event Limit (events) 10 (email and SMS)
Datalog
Enabled Yes
PDU Enabled
Branch Enabled
Receptacle Enabled
Logging Interval (minutes) 15
Manage Protocol
Velocity v.4 Server Enabled
SNMPAgent Enabled
SSHSupport Enabled
Telnet Enabled
Web Server Enabled
Inactive Session Timeout 5 minutes
Maximum Telnet Sessions 5
Table 6.1 Factory Default Settings
Vertiv | RPC2™ Communications Module Installer/User Guide | 50