1x Saddle (including screws)
As soon as the e-bike has been removed from the box, lay it carefully on the ground. The front wheel is not installed yet so
to avoid any possible damage place the lower part of the front fork on a soft surface.
1x Box containing 2 side reflectors, 1 battery charger, 2 keys
1x Box containing tools (see section 5 in this manual)
1x Box containing 1 front headlight and 2 headlight brackets
We recommend you store the box and the packaging material. In case of return you will be asked to accurately
pack the e-bike in order to safely ship it. An improper packaging might provoke serious damages to the e-bike
during the transportation.
After removing the e-bike, inside the box you can find the following parts:
You can now remove all the polyurethane foam covering the different parts of the e-bike. Use a wire cutter to
cut the cable ties. These ties are quite hard to cut so it is not advisable to use such tools as scissors or knives,
which might hurt you or those around you.
We recommend you perform the assembly operations on a clean and dry surface. The whole setup requires around 30
minutes.
To Next Page
Loading...
